26
English
Plug and Play
Plug and Play allows you to store all available radio stations
automatically.
First time setup/power up
1 When you turn on the power, "AUTO INSTALL - PRESS
PLAY" is displayed.
2 PressÉÅ on the system to start installation.
➜ "INSTALL TUNER" is displayed, followed by "AUTO
PROGRAM".
➜ The system will automatically store the radio stations
with sufficient signal strength, starting with FM band and
followed by AM band. Weak radio stations may be stored
in later presets.
➜ When all the available radio stations are stored or the
memory for 40 presets is used, the last preset radio station
will be played.
To reinstall the Plug and Play
1 In standby mode, hold downÉÅ on the system until
"AUTO INSTALL - PRESS PLAY" is displayed.
2 PressÉÅ again to start installation.
➜ All previously stored radio stations will be replaced.
To exit the Plug and Play
● Press Ç on the system.
➜ If you do not complete the Plug and Play installation, the
function will be restarted when you turn on the power
again.
Notes:
– If no stereo frequency is detected during Plug and Play,
"CHECK ANTENNA" will be displayed.
– During Plug and Play, if no button is pressed within 15
seconds, the system will exit Plug and Play mode.
Tuning to radio stations
1 Press SOURCE to select TUNER mode (or TUNER on
the remote control.
2 Press TUNER again to select the desired band : FM or AM.
3 Hold down S or T until the frequency indication
starts to change, then release.
➜ The system automatically tunes to the next strong signal
radio reception.
● To tune to a weak station, press S or T briefly
and repeatedly until an optimal reception is found.
4 Repeat step 3 if necessary until you find the desired radio
station.
Presetting radio stations
You can preset up to 40 radio stations in the memory.
Automatic preset from a desired preset
number
1 In tuner mode, press 1 or 2 or use the numeric keypad
(0-9) to select the desired preset number.
2 Hold down PROG until “AUTO PROGRAM” is displayed.
➜ If a radio station has been stored in one of the presets,
it will not be stored again under another preset number.
➜ If no preset number is selected, automatic preset will
begin from preset (1) and all your former presets will be
overridden.
To exit the preset setting
● Press PROG or Ç on the system.
Manual preset of favorite radio stations
1 Tune to your desired radio station (refer to “Tuning to radio
stations”).
2 Press PROG twice.
➜ The preset number starts flashing.
3 Press 1 or 2 or use the numeric keypad (0-9) on the
remote control to select the desired preset number.
4 Press PROG again to store the radio station.
● Repeat steps 1–4 to store other radio stations.
5 To exit, press Ç.
Notes:
– If you attempt to program more than 40 preset radio
stations, "PROGRAM FULL" is displayed.
– During programming, if no key is pressed within 15
seconds, the system will exit the program mode automatically.
Radio Reception
RADIO RECEPTION
