10
English
Connecting the speakers
Connect the supplied speaker systems using the supplied
speaker cables by matching the colors of the jacks and
speaker cables.
1 Press up (or down) the clip on the speaker’s jack and fully
insert the stripped portion of the speaker cable into the
jack, then release the clip.
8 mm
abc
2 Connect the subwoofer’s AUDIO INPUT jack to the
WOOFER LINE OUT jack and then connect the
speakers as follows :
Speakers
- +
Front Right (R) (FR) black red
Front Left (L) (FL) black white
Center (C) black green
Surround Right (SR) black gray
Surround Left (SL) black blue
(for model LX8000SA only)
Before connecting the
speakers;
● Set up the speaker stands
(refer to the accompanying
“Installation Guide”) or/and
mount the speakers onto the
mini speaker stands as shown in
the illustration.
● Remove the protective cover
only after the connection and
installation of speakers are
completed.
Notes:
– Ensure that the speaker cables are correctly connected.
Improper connections may damage the system due to short-
circuit.
– For optimal sound performance, use the supplied speakers.
– Do not connect more than one speaker to any one pair of
+/- speaker jacks.
CONNECTIONS
– Do not connect speakers with impedance lower than the
speakers supplied. Please refer to the SPECIFICATIONS
section of this manual.
Connecting a TV
You must connect a TV to the DVD system in order to use
the DVD player.
To listen to the TV broadcast channels
through the home cinema sound system
● Use the supplied audio cables to connect the system’s
AUDIO-TV IN (L/R) jacks to the corresponding
AUDIO OUT jacks on the TV.
IMPORTANT!
There are various ways to connect the system to a
TV (as shown in the illustration below). You only
need to make
ONE of the best connections,
depending on the capabilities of your TV system.
If your TV has a S-video input connector
● Use the S-video cable to connect the system’s
S-VIDEO jack to the S-Video input jack on the TV.
If your TV has a component video
(Pr/Cr Pb/Cb Y) input connector
1 Use the Pr/Cr Pb/Cb Y cables to connect the system’s
Pr/Cr Pb/Cb Y jacks to the corresponding
Pr/Cr Pb/Cb Y In jacks on the TV.
2 for model LX8000SA only - If your TV can accept
progressive signals, move the P-SCAN switch (located
at rear panel) to “ON”.
Note:
– The progressive scan video quality is only possible through
Pr/Cr Pb/Cb Y output.
If your TV is not equipped with Pr/Cr Pb/Cb Y
or S-Video input connector
● Use the video cable to connect the system’s CVBS jack to
the video input jack on the TV.
Note: On the TV,
– The S-Video In jack may be labeled Y/C, S-Video or S-VHS.
+
+
AM
F
M
/A
M
A
N
T
E
N
N
A
FM 75
Ω
S
-V
ID
E
O
C
V
B
S
VIDEO OUT
AUDIO
AUX
IN
TV
IN
LINE
OUT
DIGITAL
OUT
CENTER
OUT
DIGITAL
IN
W
OOFER
LINE OUT
P
r
/C
r
P
b
/C
b
Y
P
-S
C
A
N
O
N
O
F
F
CDR
Pr/Cr
Pb/Cb
Y
