13
English
Inserting batteries into the
remote control
1 Open the batter y compartment.
2 Place the batteries in the
compar tment with the correct
polarity as indicated by “+“ and “-“
symbols.
3 Close the cover.
CAUTION!
– Remove batteries if they are exhausted or will
not be used for a long time.
– Do not use old and new or different types of
batteries in combination.
– Batteries contain chemical substances, so they
should be disposed off properly.
Switching on the system
1 After completing all the connections, connect the AC
power cord of the DVD system and subwoofer to the
power outlet.
● The first time you turn on power,
"AUTO INSTALL - PRESS PLAY" may appear on the
display screen. PressÉÅ on the system to star t
installation or press Ç to exit (refer to “Radio Reception -
Plug and Play”).
2 Press SOURCE button (or press TV/AV, DISC, TUNER
or AUX/DI) to select the input source.
➜ The selected source will be displayed.
● For viewing a DVD or VCD, a TV needs to be connected
(refer to “Connections - Connecting a TV”).
Switch on the TV and set it to the correct video in channel
(for example, EXT1, EXT2, AV1, AV2). Refer to your TV
instruction manual for details.
➜ The default screen appears on the TV.
● You can connect other equipment to the DVD system in
order to use the Home Cinema Audio System’s surround
sound capabilities. For example, connect to a TV and select
TV/AV as the input source or connect to a VCR and select
AUX as the input source.
IMPORTANT!
– If your TV screen is only showing a black/white
picture or the picture is completely distorted,
please refer to “NTSC/PAL setting” or “System
Setup (DVD) - TV system”.
– If you do not get a proper picture or sound,
please refer to “System Setup (DVD)” in order to
change the pre-settings as necessary to
accommodate your TV system or change to your
preferred settings.
NTSC/PAL setting
Set the DVD system to NTSC or PAL, whichever matches
your TV. The factory default setting is NTSC. s ing
is necessary if you connected the DVD system to a
PAL TV only.
1 Press SOURCE or DISC
to select disc mode.
➜ Make sure that no disc
is inside the disc tray.
2 Hold down DISC on the
remote control until the
current setting (NTSC or
PAL) appear on the display.
3 If you want to change the tting, repeat step 2.
PREPARATIONS
☞
