25
3 Press to select [Video Setup].
4 Select [Progressive] > [On], then press OK.
A warning message is displayed.»
5 To proceed, select [Ok] and press OK.
The progressive setup is complete.»
Note
If a blank/distorted screen is displayed, wait for 15
seconds for the auto recovery.
If no picture is displayed, turn off the progressive scan
mode as follows:
1) Press
to open the disc compartment.
2) Press the
Numeric button ‘1’.
6 Press SETUP to exit the menu.
7 You can now turn on the progressive scan
mode on the TV (see the TV user manual).
Note
During play, when the progressive scan mode is on for
both this product and the TV, distorted picture may
display. In this case, turn off the progressive scan feature
on both this product and the TV.
Use Philips EasyLink
This product supports Philips EasyLink which uses the
HDMI CEC (Consumer Electronics Control) protocol.
You can use one single remote control to control
EasyLink-compliant devices that are connected
through HDMI connectors.
Note
To enable the EasyLink feature, you must turn on the
HDMI CEC operations on the TV and on other devices
connected to TV. Refer to the TVs/devices manual for
details.
One-touch play
1
Press the STANDBY button to turn on this
product.
The TV (if supports one-touch play) »
automatically turns on and switches to the
correct video-in channel.
If a disc is loaded in this product, disc play »
automatically starts.
Select menu display language
Note
If this product is connected to a HDMI CEC compliant
TV, skip this setting. It switches automatically to the
same OSD menu language as per your TV setting (if the
language set on TV is supported by this product).
The language options may vary from different
regions.
1 Press SETUP.
» [General Setup] menu is displayed.
2 Select [OSD language], then press .
3 Press to select a language, then press OK.
Turn on progressive scan
Note
To use the progressive scan feature, you must connect
a progressive scan TV with the component video jacks
(see “Connect” > “Connect video cables” > “Option 2:
Connect to the component video jacks” for details).
1 Turn on the TV to the correct viewing channel
for this product.
2 Press SETUP.
English
EN
