28
Basic Operations—Continued
You can choose what name is displayed when an input source is selected so that it matches the type of component that
you’ve connected to the MD/TAPE IN, DOCK/CDR IN, or OPTICAL DIGITAL IN (CR-725DAB only). When you
connect an Onkyo -capable component, it’s important that you select the input source name that matches the type of
component for to work properly.
You can also use the front panel controls.
1 Use the [INPUT] button to select the input source
whose name you want to change.
2 Push the multi control to select “Name Select?,” and
then push it again.
3 Turn the multi control to select the new input source
name.
4 Push the multi control to confirm your selection.
Input Source Name Abbreviations
Sometimes the input source name may be displayed as a
2-letter abbreviation, as per the following table.
Changing the Input Display
1
Use the INPUT [ ]/[ ] buttons
to select the input source whose
name you want to change.
CR-725DAB: TAPE, DOCK, DIGI-
TAL
CR-725: TAPE, DOCK
2
Press and hold the [MENU/NO]
button until “Name Select?”
appears on the display, and then
press [ENTER].
3
Use the Previous or Next
[ ]/[ ] button to select the
new input source name.
The input source names are selected in
the following orders:
/
MENU/NO
ENTER
INPUT
/
HOLD
MDTAPE VIDEO*
DAT*
DOCK CD-R
PC
(CR-725DAB only)
* When you select an input source name,
you cannot select it as the recording com-
ponent at the set timer recording.
4
Press [ENTER] to confirm your
selection.
“Complete” appears on the display.
Full name Abbreviation
CDR CR
DAT DT
DIGITAL DG
GAME GM
DOCK DC
LINE LI
LINE1 L1
LINE2 L2
MD MD
PC PC
TAPE TP
VIDEO VD
DIGITAL CD-R/dig
GAME/dig PC/dig
