24
Connecting Other Components—Continued
The following diagram shows how to connect a portable audio device (e.g., MP3 player, MD player, CD player).
Connect the CD receiver’s LINE 2 IN jack on the front panel to the portable audio device’s output jack.
Depending on the type of output jack on the portable audio device, you may need to buy a suitable cable. The CD
receiver’s LINE 2 IN jack accepts a stereo miniplug.
Notes:
• Use a connecting cable that doesn’t have any attenuation resistors in it.
• If you connect a portable audio device’s headphone output to the CD receiver’s LINE 2 IN jack, turn down the volume
on the portable audio device before you connect it.
• When you connect a portable audio device to the CD receiver, make sure you connect it to the LINE 2 IN jack and
not the adjacent PHONES jack. If you connect to the PHONES jack by mistake, it may cause the PHONES output to
malfunction.
Connecting the Power Cord
Notes:
• Before connecting the power cord, connect all of your speakers and AV components.
• Turning on the CD receiver may cause a momentary power surge that might interfere with other electrical equipment
on the same circuit. If this is a problem, plug the CD receiver into a different branch circuit.
Plug the power cord into a suitable wall outlet.
The STANDBY indicator lights up.
Note:
To set the clock with the AccuClock function, the CD receiver must be able to receive RDS radio stations, which means
an FM antenna must be connected (see page 15).
Connecting a Portable Audio Device
: Signal flow
CD receiver’s front panel
Stereo miniplug cable
Portable audio device’s output jack
To wall outlet
Power cord
