Rear power window switch
The rear power window switches open or close
only the corresponding windows. To open the
window, push theswitch and hold itdown
᭺
1
.To
close the window, pull the switch up
᭺
2
.
Locking passengers’ windows
When the windowlock button is depressed,only
the driver’s side window can be opened or
closed. Push it again to cancel the window lock
function.
Automatic operation
To fully open a window equipped with automatic
operation, press the window switch down (only
driver’s side shown) to the second detent and
release it; it need not be held. The window auto-
matically opens all the way. To stop the window,
lift the switch up while the window is opening.
To fully close a window equipped with automatic
operation,pulltheswitch uptotheseconddetent
and release it; it need not be held. To stop the
window,press theswitchdown whilethewindow
is closing.
Auto-reverse function
The auto-reversefunction can be activatedwhen
a window is closed by automatic operation.
Depending on the environment or driving
conditions, the auto-reverse function may
be activated if an impact or load similar to
something being caught in the window oc-
curs.
WARNING
There are some small distances immedi-
ately before the closed position which
cannot be detected. Make sure that all
passengers have their hands, etc., inside
the vehicle before closing the window.
If the vehicle’sbattery is disconnected, replaced,
or jump started, the power window auto-reverse
function may not operate properly. If this occurs,
please contact the dealer to re-initialize the
power window auto-reverse system.
If the control unit detects something caught in a
window equipped with automatic operation as it
is closing, the window will be immediately low-
ered.
LIC0581 LIC0410
2-50 Instruments and controls
