Keyfob operation:
● Push the
button on the keyfob.
All doors lock. The hazard lights flash
twiceandthehornbeepsoncetoindicate
all doors are locked.
● When the
button is pushed with
all doors locked, the hazard lights flash
twice and the horn beeps once as a re-
minder that the doors are already locked.
The horn may or may not beep. Refer to
“Silencing the horn beep feature” (vehicles
without navigation system) in the “Pre-
driving checks and adjustments” section or
“Vehicle electronic systems” (vehicles with
navigation system) in the “Display screen,
heater,air conditioner,audioand phonesys-
tems” section.
4. Confirm thatthe
indicator light comes
on. The
light stays on for about 30
seconds. Thevehicle securitysystem is now
pre-armed. After about 30 seconds the ve-
hicle security system automatically shifts
intothe armedphase.The
lightbegins
to flash once every 3 seconds. If, during the
30-second pre-arm time period, the door is
unlocked by the key or the keyfob, or the
ignition switch is placed to ACC or ON, the
system will not arm.
● If thekey isturned slowlywhen locking
the door, the system may not arm. Fur-
thermore, if the key is turned beyond
the vertical position toward the unlock
position to remove the key, the system
may be disarmed when the key is re-
moved. If the indicator light fails to
glow for 30 seconds, unlock the door
once and lock it again.
●
Even when thedriver and/or passengers
are in the vehicle, the system will arm
withall doorsclosed andlockedwith the
ignition switch in the OFF position.
● The lockable bedside storage com-
partment (if so equipped) is not pro-
tected by the vehicle security system.
Vehicle security system activation
Thevehicle securitysystemwill givethe following
alarm:
● The headlights blink and the horn sounds
intermittently.
● The alarm automatically turns off after ap-
proximately50 seconds.However, thealarm
reactivates if the vehicle is tampered with
again.Thealarmcanbeshut offbyunlocking
the driver’s door with the key or by pressing
the
button on the keyfob.
The alarm is activated by:
● opening a door without using the key or
keyfob (evenif thedoor is unlockedby using
the inside lock knob or the power door lock
switch).
How to stop an activated alarm
The alarm stops only by unlocking the driver’s
doorwith thekey orbypressing the
button
on the keyfob.
NISSAN VEHICLE IMMOBILIZER
SYSTEM (if so equipped)
The NISSAN Vehicle Immobilizer System will not
allow the engine to start without the use of a
registered key.
If the engine fails to start using a registered key
(for example, when interference is caused by
another registered key, an automated toll road
device or automatic payment device on the key
ring), restart the engine using the following pro-
cedures:
1. Leave the ignition switch in the ON position
for approximately 5 seconds.
2. Turn theignition switch to the OFF orLOCK
position, and wait approximately 10 sec-
onds.
2-26 Instruments and controls
