User Manual for the NETGEAR RangeMax™ Wireless PC Card WPN511
Basic Setup 3-7
February 2005
Verify wireless connectivity to your network.
a. Verify that your Connection and Status Monitor information matches your wireless
network.
b. Check the two LEDs on the WPN511:
c. Verify connectivity to the Internet or network resources.
Note: If you are unable to connect, see troubleshooting tips in the Basic Installation section
of the Reference Manual on the NETGEAR RangeMax™ Wireless PC Card WPN511
Resource CD.
LED 1
LED 2
Table 3-1. LED Descriptions
LED 1 LED 2 Meaning
S low b link O F F P ower save m od e (d efau lt from p ower u p or reset)
Alternate
blink
Alternate
blink
Looking for network association
Power LED goes ON; Network LED is OFF; then Power
LED goes OFF and Network LED goes ON
Slow blink Slow blink A ssociated or joined with network; no activity
Fast blink Fast blink Associated or joined with network; blink rate increases
wi th a ctivity on th e n e twork ove r th e a i r or loca lly on th e
network
OFF OFF No power applied to the card
