4
ASSEMBLY INSTRUCTIONS
Please refer to the following sections when preparing the mower
for it’s rst use
GRASS CATCHER
1. Position the two catcher halves as shown in (Figure 1A).
Ensure the catcher door is pushed down rmly onto the
catcher to lock in place.
Align the locating lugs marked 1 & 2 at the front of the catcher.
With the catcher base on the ground, push the top section on
each side of locator lug 1 until it clicks into place. (Figure 1B)
Repeat this process for locator lug 2
2. Continue working from the front and push each locator lug into
position from number 1 through 8 until completed. i.e. start
with locator lug number 1 then 2, 3, 4, 5, 6, 7, and 8. (Figure 1A)
3. WARNING: DO NOT HIT THE CATCHER WITH YOUR
HAND OR A MALLET. This will break the plastic. ALWAYS
START AT POSITION 1. Do not try to assemble the catcher
from any other starting point as this will make it difcult to
assemble the clips.
4. Before use, check that all the lugs are completely clipped. Test
the assembly by holding the top handle and pushing down on
the base of the catcher. (Figure 1C)
1
2
3
4
5
6
7
8
ASSEMBLY INSTRUCTIONS
Please refer to the following sections when preparing the mower for
GRASS CATCHER
1. Position the two catcher halves as shown in (Figure 1A).
to lock in place.
Align the locating lugs marked 1 & 2 at the front of the catcher.
With the catcher base on the ground, push the top section on
each side of locator lug 1 until it clicks into place. (Figure 1B)
Repeat this process for locator lug 2
2. Continue working from the front and push each locator lug into
position from number 1 through 8 until completed. i.e. start with
locator lug number 1 then 2, 3, 4, 5, 6, 7, and 8. (Figure 1A)
3. WARNING: DO NOT HIT THE CATCHER WITH YOUR
HAND OR A MALLET. This will break the plastic. ALWAYS
START AT POSITION 1. Do not try to assemble the catcher
from any other starting point as this will make it difficult to
assemble the clips.
4. Before use, check that all the lugs are completely clipped. Test
the assembly by holding the top handle and pushing down on the
base of the catcher. (Figure 1C)
Figure. 1A
Figure. 1B
Figure. 1C
1. List of Components:
A. Lower Catcher
B. Upper Catcher
C. Mid Handle Assembly
D. Upper Handle Assembly
AU
5
ASSEMBLY INSTRUCTIONS
1. List of Components:
A. Lower Catcher
B. Upper Catcher
C. Mid Handle Assembly
D. Upper Handle Assembly
2. Accessory Pack
1) Mid Handle Locking Knobs (2)
2) Mid Handle Bolts (2)
3) Mid Handle Locking Plate hole (2)
4) Mid Handle Knob Spacer (2)
5) Upper Handle Locking Knobs (2)
6) Control Box Screws (4)
7) Battery cable clips (2)
8) Air intake tube clips (1)
2
3
4
5
7
6
8
B
A
