McCulloch Corporation M48A Manual

A SERVICE OF

next previous

AU

9

FITTING THE MULCHING PLUG TO THE MOWER (OPTIONAL)

1. Stop the engine.

2. Make sure the discharge chute and the underside of the mower are clean. If not, clean the mower.

3. Raise the ap with left hand, and using the hand-hold on the mulching plug, insert the mulching plug, with

the angled section to the mowers right, into the discharge chute. Make sure the back of the plug is sitting

on the rear axle, then lower the ap.

AU

1. Stop the engine.

2. Make sure the discharge chute and the underside of the mower are clean. If not, clean the

mower.

3. Raise the flap with left hand, and using the hand-hold on the mulching plug, insert the

mulching plug, with the angled section to the mowers right, into the discharge chute. Make

sure the back of the plug is sitting on the rear axle, then lower the flap.

Fig. 8A

Fig. 8B

FITTING THE MULCHING PLUG TO THE MOWER (OPTIONAL)

12