64
Appendix
TipsSettingsConnections
Contents
Front panel Rear panel IndexRemote
Playback
Sleep timer function
You can have the power automatically switched to standby once a set
time has elapsed. This is convenient for listening while going to sleep.
1
Press SLEEP and display the time you want to set.
•The
indicator on the display lights.
•You can set the sleep timer in the range from 10 to 90 minutes in
steps of 10 minutes.
2 To cancel the sleep timer
Press SLEEP to set ”Sleep 1 O”.
The
indicator on the display turns o.
%
•The sleep timer is also cancelled when this unit is set to the standby mode.
•To check the time remaining until the sleep timer is activated, press SLEEP.
Checking the current time
2 Checking the current time when the power is
on
Press CLOCK.
•Press once more and the display returns to its original condition.
2 Checking the current time when the power is
set to standby
Press CLOCK.
•When “Network Control” (vpage74) is set to “On”, the current
time is displayed during standby.
Press CLOCK again, and the current time disappears.
•When Network Standby is set to “O”, the current time is displayed
for approximately 30 seconds, and then automatically disappears.
NOTE
•The time cannot be set when in the standby mode. Turn on the power first.
Switching the display’s brightness
1
Press DIMMER.
•The display brightness is adjusted each time DIMMER is pressed.
100% (Default) / 75% / 50% / 25% / O
%
•If you operate the buttons when the display’s brightness is set to “O”, the display
temporarily lights at the 25% brightness level.
