Chapter 3
Advanced Configuration
22
Simultaneous Dual-Band Wireless-N Router
Click Apply to save your changes. Your new entry will
appear in the Summary list.
Voice Device
Voice Device
Enter a Name Enter a name for your voice device.
MAC Address. Enter the MAC address of your voice
device.
Priority Select the appropriate priority: High, Medium,
Normal, or Low.
Click Apply to save your changes. Your new entry will
appear in the Summary list.
Summary
This lists the QoS entries you have created for your
applications and devices.
Priority This displays the bandwidth priority of High,
Medium, Normal, or Low.
Name This displays the application, device, or port
name.
Information This displays the port range or MAC address
entered for your entry. If a pre-configured application or
game was selected, there will be no valid entry shown in
this section.
Remove Click this button to remove an entry.
Edit Click this button to make changes.
When you finish making changes to this screen, click Save
Settings to save the changes, or click Cancel Changes to
undo your changes. For more information, click Help.
Administration > Management
The Administration > Management screen allows the
network’s administrator to manage specific Router
functions for access and security.
Administration > Management
Router Password
Router Access
Router Password Enter a new Password for the Router.
Re-enter to confirm Enter the Password again to confirm.
Local Management Access
Access via HTTP (HyperText Transport Protocol) is the
communications protocol used to connect to servers on
the World Wide Web. HTTPS uses SSL (Secured Socket
Layer) to encrypt data transmitted for higher security.
Select the HTTP or HTTPS check box. The default selection
is HTTP.
Access via Wireless If you are using the Router in a public
domain where you are giving wireless access to your guests,
you can disable wireless access to the Router’s web-based
utility. You will only be able to access the web-based utility
via a wired connection if you disable the setting. Keep the
default, Enabled, to enable wireless access to the Router’s
web-based utility, or select Disabled to disable wireless
access to the utility.
Remote Management Access
Remote Management To access the Router remotely
from the Internet, select Enabled.
Access via Select HTTP or HTTPS communications
protocols for remote access from the Internet.
Remote Upgrade Select Enabled to be able to upgrade
the firmware remotely from the Internet.
