Setting up the network printer
Paper handling
Maintenance
Troubleshooting
Administration
Index
6
Printing
www.lexmark.com
Lexmark E320/E322 Printer
1 Press the operator panel button with a brief button press to print a network settings
page.
Look under the TCP/IP heading on the network setup page to see if there is an IP
address listed for the print server and that the TCP/IP protocol is turned on
(activated).
If TCP/IP is turned off, use the IPX protocol to activate it. Select the printer and then
select the TCP/IP task. Check the Enable box to activate TCP/IP.
2 Issue a ping command to the print server.
ping
157.184.8.231
3 Establish an FTP session with the print server. Expect the print server to return its
current firmware level (such as 2.5.15).
ftp
157.184.8.231
4 Using the FTP “put” command, print a file. This file can be PCL or PostScript
emulations, PDF, HTML, or any other printer language the printer understands. If the
file prints, this confirms the TCP/IP protocol is working properly in the print server.
put mytest.ps or
put mytest.txt
