MUTE
TIGHT
CHANNEL
1
2
3
DAMPING AMP
REVERB
REVERB REVERB
1
2 3
TREBLE
TREBLE
TREBLE
MIDDLE
MIDDLE MIDDLE REVERB FX MIX PRESENCE
BASS
BASS
BASS
VOLUME
INPUT
MASTER
MASTER
VOLUME 2
VOLUME 1
BRIGHT MODERN
BRIGHT BRIGHT
XPAND
MODERN
BOOST
DRIVE DRIVE
T T100
INPUT: Single jack input for connecting your instrument. Only use good quality guitar cable.
CHANNEL 1 SWITCH: Press in to activate Channel 1, the led will illuminate when active. Channel 1 is designed to give
the crispest clean tones around. This switch is footswitchable and midi controllable, for more information on midi see the midi
section later in the manual.
VOLUME: Sets the level of the clean channel channel pre-amplifier.
BRIGHT: Adds brightness and life to the treble frequencies of your guitar. This switch has more effect at low clean volume
settings. Use in conjunction with the treble control (7) for optimum performance.
BASS, MIDDLE, TREBLE: These are a traditional set of passive tone controls. Passive controls have the advantage of
always sounding musical at any of their settings mainly due to their unique interactive nature. This gives players a more natural
set of tools to create their ideal sound. (Try them all set at midway (5) as a good starting point)
REVERB: Controls the amount of signal sent to the onboard reverb from each channel. The reverb in the TT is a legendary
Sound Enhancements aka ‘Accutronics Reverb’. The only choice for that authentic reverb sound. Use in conjunction with the
overall reverb level control in the master section (26) to set the amount of reverb you actually hear.
FRONT PANEL CONTROLS
Laney
OPERATING INSTRUCTIONS
Page 6/24
11
55
TT5 C
/T
1
0
C
0 T
0
4
4
10
10
13
13
11
11
15
15
2
2
14
14
9
9
21
21
22
22
23
23
6
6
7
7
8
8
24
24
25
25
26
26
27
27
28
28
3
3
12
12
17
17
18
18
16
16
19
19
20
20
5
5
6
6
7
7
8
8
5
5
6
6
7
7
8
8
