POWER INLET SOCKET: Connect to your power source. Make sure the specified voltage is correct for your country!
POWER FUSE: This is the main safety fuse for the unit. The fuse protects the AC power to the amplifier. USE ONLY THE
CORRECT SIZE AND RATING OF FUSE AS SPECIFIED ON THE PANEL. If a fuse blows or fails and a replacement of the
same size and rating is installed and it in turn blows, the amplifier has suffered a malfunction internally and needs immediate
service from a qualified technician. DO NOT TRY USING A FUSE OF HIGHER RATING. Using a fuse that is too large in
current rating may cause serious, irreparable damage to the amplifier and presents a serious fire hazard. The mains fuse ratings
are detailed in the specs section at the rear of this manual
HT FUSE: This fuse protects the DC power to the tubes within the amplifier. USE ONLY THE CORRECT SIZE AND
RATING FUSE AS SPECIFIED ON THE PANEL. If a fuse blows or fails and a replacement of the same size and rating is installed
and it in turn blows, the amplifier has suffered a malfunction, at this point check the output tubes and replace faulty ones if
required. Should tubes not be the problem the amplifier should be checked out by a qualified technician. Do not try using a
fuse of greater value. Using a fuse that is too large in current rating may cause serious, irreparable damage to the amplifier.
Fuses are designed to protect, do not take chances.
POWER: Main power switch for the unit.
(Always switch off and disconnect the power cord when not in use)
LINE OUT: Provides a line level output taken immediately prior to the power stage for connection to other line level
equipment such as a mixing desk/other sound reinforcement or even another TT amplifier via the FX return.
Laney
OPERATING INSTRUCTIONS
Page 10/24
3131
REAR PANEL CONTROLS
T
T
5
C
/T
T
10 C
0
0
30
30
40
40
42
42
43
43
44
44
45
45
32
32
33
33
34
34
35
35
36
36
37
37
38
38
39
39
41
41
