Kenwood KDC-MP745U Manual

A SERVICE OF

next previous

English

|

57

Press the [MENU] button for at least 1 second,

and then press it again briefly.

⁄

• YoucannotChannelsearchuntilthecategory

information is acquired.

Preset Memory

Putting the channel in the memory.

1

Select the channel you wish to store in the

preset memory

2

Enter Menu List mode

Press the [MENU] button.

3

Enter Preset Memory mode

Turn the [VOL] knob and press it when the

desired item is displayed.

Select “List & Memory”.

4

Select the number to put in the memory

Turn the [VOL] knob and press [VOL] knob for

at least 2 seconds when the desired item is

displayed.

Select preset number.

Cancelling the Preset Memory mode

Press the [MENU] button for at least 1 second,

and then press it again briefly.

⁄

• Onlythechannelnumberisstored.Categoryinformation

is not stored.

Preset Tuning

Recalling the channels in the memory.

1

Select Satellite Radio source

2

Enter Menu List mode

Press the [MENU] button.

3

Select a desired station in the memory

Turn the [VOL] knob and press it when the

desired item is displayed.

Select “List & Memory” > Preset number.

Channel Scan

Every receivable Channel is checked for 10 seconds.

1

Select Satellite Radio source

2

Enter Menu List mode

Press the [MENU] button.

3

Enter Channel Scan

Turn the [VOL] knob and press it when the

desired item is displayed.

Select “Channel Scan”.

4

Start Channel Scan

Turn the [VOL] knob and press it when the

desired item is displayed.

Select “YES”.

5

Release it when the channel you want to listen

to is received

Press the [VOL] knob.

Function of remote control

Direct Access Tuning

Entering the channel and tuning.

1

Select Satellite Radio source

2

Enter Direct Access Tuning mode

Press the [DIRECT] button on the remote

control.

“– – – –” is displayed.

3

Enter the channel

Press the number buttons.

4

Tune in to the entered channel

Press the [4] or [¢] button.

Cancelling Direct Access Tuning

Press the [DIRECT] button on the remote

control.

⁄

• Ifyoumakenobuttonoperationfor10seconds,the

Direct Access Tuning mode is automatically canceled.

• IfyoucannotreceiveanysignalintheinputChanneldue

to bad conditions on radio wave or other such problems,

“Acquiring Signal”/ “No Signal” appears.