50
9 CONNECTIONS AND MAINTENANCE
New2001
■ Optional unit installation
CAUTION: DISCONNECT the DC power cable from the
transceiver before performing any work on the transceiver.
Otherwise, there is danger of electric shock and/or equip-
ment damage.
See the following the case disassembly procedure when you
want to install an optional unit.
q Remove the 12 screws and open the transceiver.
w Turn the transceiver upside down, then disconnect the 3
flat cables and Rear mic connector (6-pin) from LOGIC
board, and Front mic connector (2-pin) and Volume con-
nector (3-pin) from AF board.
e Install an optional unit to J3 on the AF board as shown
below.
r Assemble the units to their original positions.
CAUTION:
• Tighten the screws with the specified torque (0.7 N.m)
when assembling the transceiver. Otherwise the trans-
ceiver may be damaged (torque too high) or lose water-
proof efficiency (torque too low).
• When unistalling the optional unit, remove it vertically.
Wiggling the unit from side to side may damage the op-
tional unit's connector.
Flat cables
LOGIC
board
Front mic
connector (2-pin)
Volume
connector
(3-pin)
Rear mic
connector
(6-pin)
AF board
!IC-M603.qxd 06.7.28 1:46 PM Page 50 (1,1)
