47
9
CONNECTIONS AND MAINTENANCE
9
New2001
CAUTION: After connecting the DC power cable, cover the
connectors with a rubber vulcanising tape as shown below,
to prevent water seeping into the transceiver.
■ Antenna
A key element in the performance of any communication sys-
tem is an antenna. Ask your dealer about antennas and the
best place to mount them.
■ Fuse replacement
One fuse is installed in the supplied DC power cable. If a fuse
blows or the transceiver stops functioning, track down the
source of the problem, if possible, and replace the damaged
fuse with a new, rated one.
■ Supplied accessories
The following accessories are supplied
■ Microphone hanger
Rest the supplied microphone on the hanger when not in use.
Connect the microphone hanger cable* to the transceiver’s
ground terminal with a self-tapping screw (3 × 8 mm) and the
other side to the microphone hanger to use the microphone
hanger function.
*Depending on version.
• If the microphone hanger function is used, Channel 16 is selected
automatically when the supplied microphone is rested on the hanger.
Mounting bracket For mounting bracket
Knob bolts
Screws (5×20)
Flat washers (M5)
Spring washers (M5)
Microphone hanger
and screws (3×16)
Microphone DC power cable
Sponges
Accessory connectors
(3 pin, 6 pin)
Microphone
hanger cable*
*Depending on version
Fuse rating: 10 A
Rubber vulcanizing
tape
!IC-M603.qxd 06.7.28 1:46 PM Page 47 (1,1)
