Hitachi Ultrastar 15K450 (FC-AL) Hard Disk Drive Specification
136
19.5.1.10 Inquiry Data Format - EVPD = 1, Page Code - D2h
Table 115: Inquiry Data - EVPD = 1 (Page Code = D2h)
• Qualifier is set to zero to indicate that the LUN specified in the Command Block is currently supported.
• Peripheral Device Type is set to zero to indicate that the device is Direct Access.
• Page Code is set to the value of the page code field in the CDB.
• Page Length is set to 52, and this field specifies the length of the following page data.
Note: If the media is not available, bytes 0 through 3 are valid. All the other fields are ASCII blanks (20h).
Note: All ASCII fields are alphanumeric, left aligned, and padded on the right with ASCII blanks (20h).
Byte
BIT
76543210
0 Qualifier = 0 Peripheral Device Type = 0
1 Page Code = D2h
2 Reserved = 0
3 Page Length = 52 (34h)
4 HDC Version Length = 16 (10h)
5 - 20 ASCII HDC Version
21 Card Serial Number Length = 16 (10h)
22 - 37 ASCII Card Serial Number
38 Card Assembly Part Number Length = 16 (10h)
39 - 54 ASCII Card Assembly Part Number
55 Reserved = 0
