Page 7SKU 96155 For technical questions, please call 1-800-444-3353.
ASSEMBLY INSTRUCTIONS
IMPORTANT: 1. If you have any doubts about your ability to perform the following
assembly procedures, you should have a qualied service technician perform the
assembly for you.
Located at the base of the Crankcase Sump (11 - page 13) are four 8mm x 1.25 2.
mounting holes. (See Figure A.)
Set the Engine upright on the power equipment unit, and align the four mounting 3.
holes of the Engine with four 8mm x 1.25 mounting holes in the power equip-
ment unit. NOTE: Depending on the power equipment unit, it may be necessary
to drill four 8mm mounting holes which will align with the mounting holes in the
Engine. (See Figure A.)
Use four 8mm x 1.25 hardened steel Bolts, Washers, Lock Washers, and self-locking 4.
Nuts (not included) of appropriate length to secure the Engine to the power equip-
ment unit. (See Figure A.)
5. CAUTION! Check to make sure the Bolts, Washers, Lock Washers, and
Nuts used DO NOT come in contact with any moving part of the Engine and
power equipment unit.
Insert the power equipment unit’s throttle control cable wire end into the hole lo-6.
cated in the Regulating Mount with Throttle (1 - page 22). Then secure the Throttle
Control Cable to the Throttle. (See Figure B.)
NOTE: 7. Refer to the power equipment unit’s owner manual for instructions on how
to properly attach a belt drive pulley, chain drive gear, etc. onto the Crankshaft
(10 - page 15) of the Engine. (See Assembly Diagram, page 15.)
MOUNTING HOLE
MOUNTING HOLE
MOUNTING HOLE
MOUNTING HOLE
BOTTOM VIEW
FIGURE A
REV 08l
