F - 160 Operation and Maintenance Manual
© GBC Pro - Tech August 1999 Page 5 - 23
Operations
5.6 Infeed tables
These tables are part of the Falcon 160 safety
features. It is neccessary to have the two infeed tables
properly positioned before running the laminator.
CAUTION
If not installed properly, you can be injured
or cause damage to the table or laminator.
5.6.1 Removing the table
Caution should always be exercised
when using the laminator with
the safety shields raised.
You can be seriously HURT or INJURED!
WARNING
a) Raise the safety shield.
b) With both hands, grip the front edge of the
infeed table and lift up and then out. Refer to
Figure 5.6.1
Figure 5.6.1 Front edge
Front edge
5.6.2 Replacing the infeed
table
a) Ensure the safety shiled is in the raised
position.
b) With both hands, grip the front edge of the
infeed table and align the back edge with the
support bolts. Refer to Figure 5.6.2
Figure 5.6.2 Back edge
Front
support bolt
