F - 160 Operation and Maintenance Manual
© GBC Pro - Tech August 1999 Page 8 - 5
Maintenance
d) Since the safety shields are raised and the
tables removed, you must use the footswitch to
rotate the bottom rollers after cleaning a
section.
Speed is controlled through the variable
speed footswitch when the safety shield
is in the raised position.
CAUTION
Method 2
a) Allow the laminator to cool slightly to no
higher than 110
o
F ( 43
o
C ).
TOP TEMP.
BOT. TEMP
SLEEP
<110 <110
b) Set the motion direction to REV t.
FWR
REV.
STOP
GO
SPEED
SAFETY
00.0
WARNING
Keep hands and fingers clear of the
laminator roller nip when changing GAP.
You can be CRUSHED or BURNED!
b) Set the nip of the rollers to the thickness of the
adhesive coated boards.
GAP
PRESSURE
1/4
WARNING
Keep hands and fingers clear of
the laminator roller nip when
adjusting PRESSURE.
You can be CRUSHED or BURNED!
c) Using the variable speed footswitch, run
the adhesive coated boards through the rolls.
d) Do this as many times as needed to clean the
laminator rolls.
