M2488 PRODUCT GUIDE DIAGNOSTIC TESTS AND ERROR CODES
April 1997 CG00000-011503 REV. A F-25
0x09
0x03 PCC Timers Timer 2 test 0x02 FMT counter 2 low count carry-out bit not set
0x03 Timer 2 running too FAST compared against
FMT counter 2.
0x04 Timer 2 running too SLOW compared against
FMT counter 2.
Table F-12. Routine 10 - EDRC Control Signals Diagnostic Error Codes
ROUTINE TEST TITLE
ERROR
CODE
DESCRIPTION
0x10 * All R20 Control Check Diagnos-
tics
0xD0 SPC register initialization failed
0xE0 SPC did not generate an interrupt request
0xE1 SPC interrupt was not detected at the Interrupt
Request Controller
0xE2 The SPC interrupt was cleared while clearing
the Interrupt Request Controller.
0xE3 SPC interrupt/step code did not report Com-
mand Complete
0xE4 The SPC interrupt request could not be
cleared
0xE5 SPC did not generate an interrupt request
0xE6 SPC interrupt was not detected at the Interrupt
Request Controller
0xE7 The SPC interrupt was cleared while clearing
the Interrupt Request Controller.
0xE8 SPC interrupt/step code did not report Diag-
nostic Self-Test passed
0xE9 The SPC interrupt request could not be
cleared
0x10 At end of test, SPC did not generate an inter-
rupt request.
0x11 At end of test, SPC interrupt was not detected
at the Interrupt Request Controller.
0x12 At end of test, the SPC interrupt was cleared
while clearing the Interrupt Request Control-
ler.
Table F-11. Routine 9 - PCC Timers Diagnostic Error Codes (Continued)
ROUTINE TEST TITLE
ERROR
CODE
DESCRIPTION
DIAGNOSTIC TESTS
AND ERROR CODES
