KEY ACCESS PROGRAMMING
Several control panel features can be programmed
quickly on the keypad, without entering any program-
ming addresses or section numbers.
Select “one-key access” programming mode by
pressing [
ENTER], followed by master or user code 1.
Then press the single key (listed below) correspond-
ing to the feature you wish to activate. (Verify first
with your installer that all of the features listed below
have been programmed and activated on your con-
trol panel. Press [ENTER] or [CLEAR] to exit.
key
[9] "Auto arming" time program
Key [9] flashes.
ÀÀ
Enter two digits (00 to 23)
for hours + 2 digits (00 to 59) for minutes.
(Press [
ENTER].)
ÁÁ
[MEM] "Panel time"
Key [
MEM] flashes.
ÀÀ
Enter two digits (00 to 23)
for hours + 2 digits (00 to 59) for minutes.
(Press [
ENTER].)
ÁÁ
[BYP] Test report
If programmed by your installer, this sends a
test report code to the monitoring station.
ÀÀ
Control panel software versions 2.00 and beyond.
ÁÁ
Control panel software versions prior to 2.00.
[TRBL] Call Espload via telephone
If programmed by your installer, this initiates
communication to the central monitoring sta-
tion computer using Espload software.
[
AWAY] Answer Espload
This feature initiates “modem” communication
between your panel and a computer running
Espload software. (The ADP-1 adapter can
also be used.)
[
STAY] Cancel communication attempts
Stops calls from/to Espload.
When communicating with Espload, it is impossible
to enter programming mode.
26
27
UM616-626UM616-626
