Programmable output
Not only does your Esprit control panel provide top
security, it also offers you total convenience. Your
installer can program the panel to reset smoke
detectors & Glasstreks, to activate strobe lights, to
activate light switches in your home or office, to
reduce or increase building temperature, turn on/off
air conditioning, open/close automatic garage
doors, and more. Talk to your installer about this
helpful feature!
Keypad night illumination
Pressing on the [MEM] key for 2 seconds changes it to
the keypad illumination key. Pressing this key will
then alter the illumination level from low, medium, to
high, and then “off”. Keep pressing the [MEM] key until
you reach the level you require, then press [ENTER] or
[CLEAR] to save the setting in system memory.
Chime zones
Zones 1 to 6, as well as the local keypad zones, can
be programmed as
chime
zones. A chime zone
"advises" you when it is opened by creating a rapid
intermittent beep tone. To turn on the "chime zone"
feature, press on the selected zone key for three sec-
onds until the intermittent chime beep is heard. This
means that the chime feature has been activated. If
a continuous beep is heard, this means that the
chime is "off". (The keypad zone chime is enabled by
pressing key [8].)
If you have more than one keypad in your system,
please "chime" program each keypad separately.
Keypad chimes must be reprogrammed if the panel
suffers total power loss.
CHIME KEYS:
Key [1]-[6] Turns chime "ON" or "OFF" in zones num-
bered 1-6.
Key [8] Turns the chime "ON" and "OFF" for the
zone connected to this keypad.
Each keypad must be programmed inde-
pendently.
PANEL BUZZER MUTE:
Key [9] Turns keypad sounder "ON" and "OFF"
(intermittent beep means MUTE is activat-
ed, and keypad sounder is "OFF".
Depress for 2 seconds to disable.)
TROUBLE DISPLAY and TROUBLE MEMORY
10 different trouble conditions can be displayed on your
keypad. When a trouble condition occurs, the [
TRBL
]
key on your keypad illuminates and if programmed by
your installer, the keypad sounder will beep. (When
“power supply failure” trouble occurs, the [
TRBL
] key
flashes rapidly.
ÀÀ
) Press on this key and it flashes, indi-
cating that your panel is in "trouble display" mode.
Control panel software versions prior to 2.00:
Keys that illuminate in "trouble display" mode tell you
which trouble conditions are taking place and/or are
ÀÀ
Control panel software versions 2.00 and beyond.
18
19
UM616-626UM616-626
