S5U1C62000A MANUAL EPSON 201
(S1C60/62 FAMILY ASSEMBLER PACKAGE)
CHAPTER 9: DEBUGGER
ta (trace area)
Function
This command sets or clears the trace area by the specified program address range.
Format
(1) >ta [<staddr1> <endaddr1> [...... <staddr4> <endaddr4>]]↵ (direct input mode)
(2) >ta all↵ (direct input mode)
(3) >ta↵ (guidance mode)
Current trace area
1. set 2. clear 3. clear all ...? <1 | 2 | 3>↵
Start address ? <staddr>↵
End address ? <endaddr>↵
......
>
<staddr1–4>:
Start address of each specified address range; hexadecimal or symbol (IEEE-695 format only)
<endaddr1–4>:End address of each specified address range; hexadecimal or symbol (IEEE-695 format only)
Condition: 0 ≤ staddr(1–4) ≤ endaddr(1–4) ≤ last program memory address
Examples
Format (1)
>ta 400 600↵ ... Sets a trace area from address 0x400 to 0x600.
>
Format (2)
>ta all↵ ... Sets as entire program memory to be traced.
>
Format (3)
>ta↵
Trace area:
0000..0fff
1. set 2. clear 3. clear all ...? 3↵ ... Clears all areas.
>ta
No trace extract address is defined
1. set 2. clear 3. clear all ...? 1↵
Start address ? 100↵ ... Sets a trace area from address 0x100 to 0x17f.
End address ? 17f↵
Start address ? 200↵ ... Sets a trace area from address 0x200 to 0x2ff.
End address ? 2ff↵
Start address ? ↵ ... Terminated by [Enter] key.
>ta↵
Trace area:
0100..017f
0200..02ff
1. set 2. clear 3. clear all ...? 2↵
Start address ? 150↵ ... Clears a trace area from address 0x150 to 0x24f.
End address ? 24f↵
Start address ? ↵
>ta↵
Trace area:
0100..014f
0250..02ff
1. set 2. clear 3. clear all ...? ↵
>
