29
E
Clock setting
To set the clock, select the “TIME Set” page from the menu.
From this page, if you hold the button (1, fig. 8) in position B
“▼” for 3 seconds, you go into clock setting mode.
On entering this function, the message “AM” flashes on the
display; if you switch the button (1, fig. 8) to position B “▼”,
the message “PM” flashes on the display; if you switch
the button (1, fig. 8) to position B “▼”, you return to the
previous step (if the time is 00:00, when you switch from
AM to PM the time 12:00 will appear).
If you switch the button (1, fig. 8), to position A “▲”, you
can set the hours, which start flashing. Each time you
press the button into position B “▼”, the count advances
cyclically in steps of 1 hour; if you hold the button down in
position B “▼”, the count advances cyclically in steps of
1 hour every second (when the button is held down
continuously, the hours do not flash).
If you switch the button (1, fig. 8), to position A “▲”, you
can set the minutes, which start flashing. Each time you
press the button into position B “▼”, the count advances
cyclically in steps of 1 minute; if you hold the button down
in position B “▼”, the count advances cyclically in steps of
1 minute every second. If the button is held in position B
“▼” for more than 5 seconds, the minutes advance by 1
every 100 ms (when the button is held in position B “▼”
continuously, the seconds do not flash).
If you switch the button to position A “▲”, the system
exits setting mode and displays the newly set time.
flashing
flashing
B
B
B
B
B
A
A
A
A
A
A
setting
flashing
flashing
setting
fig. 23
