DXS/DWS 3200 Series User Guide
Page 152
– Unchecked — Maintains the access points.
• Remove — Removes access points. The possible field values are:
– Checked — Removes the selected access point.
– Unchecked — Maintains the current access points.
Adding a New Access point
1. Connect the AP to the switch. The switch discovers the AP.
2. Click . The WTP edit screen opens:
Figure 93: WTP Edit Screen
The WTP Edit screen contains the following fields:
• AP Name — Indicates the AP name (Max. 32 alphanumeric symbols)
•Anable AP — Enables/Disables the AP
• Key — Indicates the WEP encryption key type, the possible field values are:
– ASCII — Indicates the WEP key is in ASCII format.
– Hex — Indicates the WEP key is in Hex format.
• Tunnel Priority — Used to configure the AP priority for VLAN tunneling.
• Tunnel Source Enable — Indicates that AP is enabled as a VLAN source via a tunnel.
• Enable WAN — Accommodates certain timing constrains in the communication to a remotely connected AP
separated by a WAN link or the Internet. To disable WAN support, use the no form of this command..
3. Select the Enable AP check box.
4. Select the key type.
5. Click . The AP is activated.
The WTP Edit Screen is also used for editing existing APs.
