DXS/DWS 3200 Series User Guide
Page 12
Figure 5: DXS/DWS-3227P Back Panel
The DXS-3200 series back panel is configured as follows:
• Reset Button — Resets the device. The Reset button does not extend beyond the device’s front panel sur-
face. This it to avoid accidental device resetting.
• 2 Stacking Connectors — The devices provide two stacking 12 Link(XG) interface ports.
•
RPS Connector — Redundant Power Supply (RPS) DC connector.
• Power Connector — AC power supply interface.
Ports Description
This section describes the device ports and includes the following topics:
• 1000Base-T Gigabit Ethernet Ports
• 10G XFP Fiber port
• CX-4 Copper Port
• SFP Ports
• Cable Specifications
1000Base-T Gigabit Ethernet Ports
The device contains a 1000 Base-TX Gigabit 24/48 port. The port is an RJ-45 port which supports half- and full-
duplex mode 10/100/1000 Mbps.
10G XFP Fiber port
10Gigabit XFP fiber port. One fixed in DXS/DWS-3227/3227P models.
Optional Modules
The 3200 series have module bays located on the back panel into which optional modules (DEM-411X and DEM-
411XT) can be inserted and then provide additional 10Gigabit copper or fiber port.
CX-4 Copper Port
An optional 10Gigabit copper port. DEM-411T expansion module is inserted in one or two bays located on the
back panel.
The following figure describes the DEM - 411T module used for a copper port:
