6. Hold the tool clear of the work surface. The contact trip safety mechanism
should return to its original down position. Pull the trigger. The tool must
not cycle. Do not
use the tool if a cycle occurs.
7. Depress the contact trip safety mechanism against the work surface. Pull
the trigger. The tool must cycle.
9 - Eng
D24156
LOADING THE TOOL
Disconnect tool from air supply before adjusting, clearing jams,
servicing, relocating or during non-operation. Failure to do so
could result in serious injury or property damage.
Make sure not to pull the trigger or depress the contact trip
safety mechanism when connecting the tool to an air compres-
sor. Serious personal injury or property damage can occur if the tool cycles.
Never place your hand or any part of your body in the fastener
discharge area of the tool when air supply is connected to the
tool. Serious personal injury may occur.
Handle the tool carefully. Respect the tool as a working
implement and always assume the tool contains fasteners:
a. Never use the tool as a toy and engage in horseplay.
b. Never aim or point the tool at anyone. The tool may contain fasteners.
c. Always keep people and animals at a safe distance from the work area in
case of accidental discharge of fasteners.
d. Never pull the trigger unless the nose of the tool is against
the work
surface.
e. Do not pull the trigger or depress the contact trip when loading the tool.
NOTE: See specification and fastener section for fastener information.
Loading the Tool
1. Disconnect air hose.
2 Depress magazine latch and slide magazine open.
Stapler
Magazine Latch
Brad Nailer
Magazine Latch
