500 | IPv6 Addressing
www.dell.com | support.dell.com
SNMP over IPv6
SNMP is supported on platforms c e s
Simple Network Management Protocol (SNMP) can be configured over IPv6 transport so that an IPv6 host
can perform SNMP queries and receive SNMP notifications from a device running FTOS IPv6. The FTOS
SNMP-server commands for IPv6 have been extended to support IPv6. Refer to the SNMP and SYSLOG
chapter in the
FTOS Command Line Interface Reference for more information regarding SNMP commands.
• snmp-server host
• snmp-server user ipv6
• snmp-server community ipv6
• snmp-server community access-list-name ipv6
• snmp-server group ipv6
• snmp-server group access-list-name ipv6
Show IPv6 Information
All of the following show commands are supported on platforms: c e s
View specific IPv6 configuration with the following commands.
Command Syntax Command Mode Purpose
telnet ipv6 address EXEC or
EXEC Privileged
Enter the IPv6 Address for the device.
ipv6 address : x:x:x:x::x
mask : prefix length 0-128
IPv6 addresses are normally written as eight groups of four hexadecimal digits,
where each group is separated by a colon (:). Omitting zeros is accepted as
described in Addressing earlier in this chapter.
Command Syntax Command Mode Purpose
show ipv6 ?
EXEC or
EXEC Privileged
List the IPv6 show options
