Filter
Top Products
PERIODIC MAINTENANCE AND MINOR REPAIR
6-41
6
EAU24310
Replacing the license plate
light bulb
1. Remove the license plate light unit
by removing the screws.
2. Remove the socket (together with
the bulb) by pulling it out.
3. Remove the defective bulb by pull-
ing it out.
4. Insert a new bulb into the socket.
5. Install the socket (together with the
bulb) by pushing it in.
6. Install the license plate light unit by
installing the screws.
EAU33910
Replacing an auxiliary light
bulb
This model is equipped with two auxil-
iary lights. If an auxiliary light bulb burns
out, replace it as follows.
1. Remove panel C (if replacing the
left auxiliary light bulb) or panel D
(if replacing the right auxiliary light
bulb). (See page 6-9.)
2. Remove the auxiliary light bulb
cover by removing the quick fas-
tener.
N
O
TE:
Remove the quick fastener by pushing
the center pin in with a screwdriver,
then pulling the fastener out.
1. License plate light unit
2. Screw
1. License plate light bulb
1. Auxiliary light bulb cover
2. Quick fastener
U4C810E0.book Page 41 Wednesday, September 27, 2006 3:06 PM