Filter
Top Products
8-12
8
TIP
The engine oil should be between the minimum
and maximum level marks.
5. If the engine oil is at or below the minimum
level mark, add sufficient oil of the recom-
mended type to raise it to the correct level.
6. Insert the dipstick into the oil filler hole, and
then tighten the engine oil filler cap.
To change the engine oil (with or without oil fil-
ter cartridge replacement)
1. Start the engine, warm it up for several min-
utes, and then turn it off.
2. Place an oil pan under the engine to collect
the used oil.
3. Remove the engine oil filler cap, and then re-
move the engine oil drain bolt to drain the oil
from the crankcase.
TIP
Skip steps 4–6 if the oil filter cartridge is not being
replaced.
1. Dipstick
2. Maximum level mark
3. Minimum level mark
1. Engine oil drain bolt
U3D513E0.book Page 12 Monday, May 19, 2008 3:19 PM