Filter
Top Products
8-43
8
3. Insert a new bulb into the socket, push it in,
and then turn it clockwise until it stops.
4. Install the lens by installing the screws.
NOTICE
ECB00700
Do not overtighten the screws, otherwise the
lens may break.
EBU25651
Removing a wheel
1. Place the ATV on a level surface.
2. Loosen the wheel nuts.
3. Elevate the ATV and place a suitable stand
under the frame.
4. Remove the nuts from the wheel.
5. Remove the wheel.
EBU25701
Installing a wheel
1. Place the ATV on a level surface.
2. Install the wheel and the nuts.
TIP
● The arrow mark on the tire must point toward
the rotating direction of the wheel.
1. Tail/brake light bulb 1. Wheel nut
U3D513E0.book Page 43 Monday, May 19, 2008 3:19 PM