Filter
Top Products
8-41
8
4. Install a new headlight bulb into the headlight
unit by aligning the projection on the bulb with
the groove in the headlight unit.
NOTICE
ECB00650
Do not touch the glass part of the headlight
bulb to keep it free from oil, otherwise the
transparency of the glass, the luminosity of the
bulb, and the bulb life will be adversely affect-
ed. Thoroughly clean off any dirt and finger-
prints on the headlight bulb using a cloth
moistened with alcohol or thinner.
5. Install the headlight bulb holder by aligning the
projections with the holes in the headlight unit,
pushing it inward, and turning it clockwise until
it stops.
6. Install the headlight bulb holder cover at the
rear of the headlight.
NOTICE
ECB00670
Make sure the headlight bulb holder cover is
securely fitted over the bulb holder and seated
properly.
7. Adjust the headlight beam if necessary.
1. Do not touch the glass part of the bulb.
U3D513E0.book Page 41 Monday, May 19, 2008 3:19 PM