Filter
Top Products
PERIODIC MAINTENANCE AND ADJUSTMENT
7-37
7
5. Remove the auxiliary light bulb
socket (together with the bulb) by
turning the socket counterclock-
wise.
6. Remove the burnt-out bulb by pull-
ing it out.
7. Insert a new bulb into the socket.
8. Install the socket (together with the
bulb) by pushing it in and turning it
clockwise.
9. Install the headlight unit by install-
ing the bolts, and then tightening
them to the specified torque.
10. Install the headlight unit cover by
installing the bolts.
11. Install the panel by installing the
quick fasteners.
12. Install the windshield by installing
the screws, and then tightening
them to the specified torque.
WARNING! A loose windshield
could cause an accident. Be
sure to tighten the screws to the
specified torque.
[EWA15510]
EAU25871
Troubleshooting
Although Yamaha motorcycles receive
a thorough inspection before shipment
from the factory, trouble may occur dur-
ing operation. Any problem in the fuel,
compression, or ignition systems, for
example, can cause poor starting and
loss of power.
The following troubleshooting charts
represent quick and easy procedures
for checking these vital systems your-
self. However, should your motorcycle
require any repair, take it to a Yamaha
dealer, whose skilled technicians have
the necessary tools, experience, and
know-how to service the motorcycle
properly.
Use only genuine Yamaha replace-
ment parts. Imitation parts may look like
Yamaha parts, but they are often inferi-
or, have a shorter service life and can
lead to expensive repair bills.
WARNING
EWA15141
When checking the fuel system, do
not smoke, and make sure there are
no open flames or sparks in the ar-
ea, including pilot lights from water
1. Auxiliary light bulb socket
1. Auxiliary light bulb
1
1
Tightening torque:
Headlight unit bolt:
7 Nm (0.7 m·kgf, 5.1 ft·lbf)
Tightening torque:
Windshield screw:
0.5 Nm (0.05 m·kgf, 0.36 ft·lbf)
U23P10E0.book Page 37 Monday, May 9, 2011 2:53 PM