Filter
Top Products
6-13
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
5
6
7
8
9
9. Install the oil filter element cover
by installing the bolts and the
drain bolt, then tightening them
to the specified torques.
NOTE:
Make sure that the O-rings are prop-
erly seated.
10. Clean the oil strainer with sol-
vent, and then check it for dam-
age and replace it if necessary.
11. Install the oil strainer, spring, O-
ring and engine oil drain bolt,
and then tighten the drain bolt to
the specified torque.
5. Remove the oil filter element
cover by removing the bolts.
6. Remove the oil filter element and
O-rings.
7. Check the O-ring for damage
and replace it if necessary.
8. Clean the oil filter element with
solvent, and then install it.
NOTE:
Check the oil filter element for dam-
age and replace it if necessary.
1. Oil filter element
2. O-ring (×2)
1
2
2
NOTE:
Skip steps 4-9 if the oil filter element
is not being cleaned.
4. Remove the oil filter element
drain bolt to drain the oil from the
oil filter element.
1. Oil filter element cover
2. Bolt (×2)
3. Oil filter element drain bolt
1
2
3
Tightening torques:
Oil filter element cover bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lb)
Oil filter element drain bolt:
10 Nm (1.0 m·kgf, 7.2 ft·lb)
5FY-9-14 (TW200, USA) 5/11/01 8:31 AM Page 52