Filter
Top Products
6-36
PERIODIC MAINTENANCE AND MINOR REPAIR
1
2
3
4
5
6
7
8
9
1. Battery
2. Battery breather hose
1
2
9. Connect and tighten the positive
battery lead to the battery’s posi-
tive (+) terminal.
10. Connect and tighten the negative
battery lead to the battery’s neg-
ative (-) terminal.
11. Install the seat.
1. Battery breather hose
1
EC000100
cC
Use only distilled water, as tap
water contains minerals that are
harmful to the battery.
7. Place the battery in the battery
compartment, and then hook the
battery band onto the holder.
8. Connect the breather hose to the
battery and make sure that it is
properly routed.
To store the battery
1. If the motorcycle will not be used
for more than one month,
remove the battery, fully charge
it, and then place it in a cool, dry
place.
2. If the battery will be stored for
more than two months, check the
specific gravity of the electrolyte
at least once a month and fully
charge the battery whenever
necessary.
3. Fully charge the battery before
installation.
4. After installation, make sure that
the battery leads are properly
connected to the battery termi-
nals and that the breather hose
is properly routed, in good condi-
tion, and not obstructed.