Filter
Top Products
Periodic maintenance and adjustment
61
8. Tighten the V-belt position adjusting
bolts.
9. Install the V-belt over the primary sheave
assembly.
10. Rotate the secondary sliding sheave
clockwise and push it so that it separates
from the secondary fixed sheave.
11. Install the V-belt between the secondary
sliding and fixed sheaves.
12. Install the drive guard, and then install the
left side cover and the shroud.
ESU12105
Drive chain housing
To check the drive chain housing oil level
1. Place the snowmobile on a level surface
and apply the parking brake.
2. Remove the shroud and the right side
cover. (See page 46 for removal proce-
dures.)
3. Remove the dipstick, wipe it off with a
clean rag, and then insert it back into the
filler hole.
1. V-belt position adjusting bolt
2. Spacer
V-belt position Adjustment
More than 1.5 mm
(0.06 in) above the
edge
Remove a spacer.
From 1.5 mm (0.06 in)
above the edge to 0.5
mm (0.02 in) below
the edge
Not necessary (It is
correct.)
More than 0.5 mm
(0.02 in) below the
edge
Add a spacer.
V-belt position adjusting bolt tightening
torque:
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
1. Secondary sliding sheave
2. Secondary fixed sheave
1. V-belt
U8FP15E0.book Page 61 Thursday, July 23, 2009 11:01 AM