Filter
Top Products
Control functions
13
and then push the “SELECT” button for at
least 3 seconds while the snowmobile is
stopped.
Odometer, tripmeter, and barometer
modes
Pushing the “SELECT” button switches the
display between the odometer mode “ODO”,
tripmeter modes “TRIP A” and “TRIP B”, and
barometer mode “BARO” in the following or-
der:
ODO → TRIP A → TRIP B → BARO → ODO
To reset a tripmeter, push the “RESET” button
for at least 1 second while the tripmeter is dis-
played.
Clock
To set the clock
1. Push the “SELECT” button and “RESET”
button simultaneously until the hour digits
start flashing.
2. Push the “RESET” button to change the
hour setting, and then push the “SE-
LECT” button. The minute digits will start
flashing.
3. Push the “RESET” button to change the
minute setting, and then push the “SE-
LECT” button. The clock starts when the
“SELECT” button is released.
TIP
The clock must be set again when the battery
is disconnected.
Display brightness control
This function allows you to adjust the bright-
ness of the meter display to suit the outdoor
lighting conditions.
To adjust the display brightness
1. Turn the main switch to the off position.
2. Push and hold down the “SELECT” but-
ton.
1. Odometer/tripmeter/barometer
1
1. “SELECT” button
2. “RESET” button
3. Clock
2
1
3
U8FP15E0.book Page 13 Thursday, July 23, 2009 11:01 AM