Filter
Top Products
Periodic maintenance and adjustment
70
Shifted to right
Shifted to left
5. Adjust the drive track deflection to speci-
fication. NOTICE: The right and left ad-
justing nuts should be turned an equal
amount.
[ECS00592]
6. Recheck alignment and deflection. If nec-
essary, repeat steps 3 to 5 until the prop-
er adjustment is achieved.
7. Lower the snowmobile to the ground.
8. Tighten the rear axle nut.
Slide runners
Check the slide runners for wear and dam-
age.
If the slide runners reach the wear limit, they
should be replaced.
1. Left adjusting nut
2. Right adjusting nut
1. Forward
2. Gap
3. Slide runner
4. Drive track
5. Slide metal
1. Forward
2. Gap
3. Slide runner
4. Drive track
5. Slide metal
Drive track
deflection
More than
specified
Less than
specified
Left adjusting
nut
Turn in Turn out
Right adjust-
ing nut
Turn in Turn out
Rear axle nut tightening torque:
75 Nm (7.5 m·kgf, 54 ft·lbf)
1. Slide runner
2. Wear limit height
Slide runner wear limit height:
10.5 mm (0.41 in)
U8FP15E0.book Page 70 Thursday, July 23, 2009 11:01 AM