Filter
Top Products
Periodic maintenance and adjustment
59
7. Check the coolant level in the coolant
reservoir. If it is not full, remove the cool-
ant reservoir cap, fill the reservoir with the
recommended coolant, and then install
the cap.
TIP
If you find any leaks, consult a Yamaha deal-
er.
8. Install the top cover.
ESU12066
V-belt
WARNING
EWS00401
● Coming in contact with the rotating V-
belt or clutch parts can cause severe in-
jury or death. Never run the engine with
the drive guard removed.
● Make sure that the drive guard is tight-
ened securely before operating the
snowmobile to protect against severe
injury or death from a broken V-belt or
other part should it come off the snow-
mobile while it is in operation.
NOTICE
ECS00830
Never run the engine with the V-belt re-
moved. Clutch components can be dam-
aged.
The V-belt should be checked before each
ride.
To check the V-belt
1. Remove the shroud and the left side cov-
er, and then remove the drive guard.
(See pages 21 and 46 for removal proce-
dures.)
2. Check the V-belt for wear and damage.
Replace if necessary.
3. Install the drive guard, and then install the
left side cover and the shroud.
To replace and adjust the V-belt
WARNING
EWS00411
When installing a new V-belt, make sure
that it is positioned properly. Otherwise,
the V-belt clutch engagement speed will
be changed and the snowmobile may
move unexpectedly when the engine is
started, which could cause an accident.
NOTICE
ECS00511
As the V-belt wears, the position of the V-
belt will change. If the V-belt position is out
of specification, it must be adjusted to en-
sure proper clutch performance.
Have a Yamaha dealer make this adjust-
ment.
1. Place the snowmobile on a level surface
and apply the parking brake.
2. Remove the shroud and the left side cov-
er, and then remove the drive guard.
(See pages 21 and 46 for removal proce-
dures.)
1. V-belt wear limit
New V-belt width:
34.5 mm (1.36 in)
V-belt wear limit width:
32.5 mm (1.28 in)
U8FP15E0.book Page 59 Thursday, July 23, 2009 11:01 AM