Yamaha MM600G Offroad Vehicle User Manual


 
8-5
Spark plugs are produced in several different thread
lengths. The thread length or reach is the distance from
the spark plug gasket seat to the end of the threaded
portion. If the reach is too long, overheating and engine
damage may result. If the reach is too short, spark plug
fouling and poor performance may result. Also, if the
reach is too short, carbon will form on the exposed
threads resulting in combustion chamber hot spots and
thread damage. Always use a spark plug with the speci-
fied reach.
Before installing any spark plug, measure the electrode gap
with a wire thickness gauge and adjust to specification.
When installing the spark plug, always clean the gasket
surface. Wipe off any grime from the threads and tighten
the spark plug to the specified torque.
ESU00145
Engine idle speed adjustment
CAUTION
:
@
Be sure to have a Yamaha dealer make this
adjustment.
Make sure that the throttle lever moves smoothly.
Make sure that the carburetor is synchronized
first.
@
1. Start the engine.
NOTE:
@
Refer to the Starting the engine section.
@
2. Turn the throttle stop screw
1
in or out to adjust the
engine idle speed.
Spark plug reach
a
: 19.0 mm (0.75 in)
Spark plug gap
b
: 0.70.8 mm (0.0280.031 in)
Spark plug tightening torque:
20 Nm (2.0 m·kgf, 14 ft·lb)
Standard engine idle speed: 1,600
±
100 r/min
E_8DG.book Page 5 Friday, June 29, 2001 4:20 PM