Yamaha FX10RTX Offroad Vehicle User Manual


 
Control functions
27
To increase the rebound damping force, turn
the adjusting dial in direction (a). To decrease
the rebound damping force, turn the adjusting
dial in direction (b).
CAUTION:
ECS00790
Do not continue to turn the adjusting
screw or dial in direction (a) after it
stops. The shock absorber can be dam-
aged and damping force adjustments
cannot be made.
Do not turn the adjusting screw or dial in
direction (b) beyond the adjustable
range. Even if the adjusting screw or dial
is continually turned beyond the adjust-
able range, there will be no change in the
damping force.
Be sure to stop the adjusting screw or
dial at a position where there is a click.
ESU13010
Adjusting the control rods (FX10MT /
FX10MTR / FX10MTRA)
The weight transfer can be adjusted by turn-
ing the control rod adjusting nut.
1. Loosen the locknut while holding the con-
trol rod adjusting nut.
2. Turn the control rod adjusting nut in direc-
tion (a) to increase weight transfer or di-
rection (b) to decrease weight transfer.
1. Rebound damping force adjusting dial
Rebound damping force setting (center):
Minimum (soft):
20 click(s) in direction (b)*
Standard:
11 click(s) in direction (b)*
Maximum (hard):
3 click(s) in direction (b)*
* With the adjusting dial fully turned
lightly in direction (a)
1. Rebound damping force adjusting dial
Rebound damping force setting (rear):
Minimum (soft):
20 click(s) in direction (b)*
Standard:
11 click(s) in direction (b)*
Maximum (hard):
3 click(s) in direction (b)*
* With the adjusting dial fully turned
lightly in direction (a)
U8GL10E0.book Page 27 Friday, May 18, 2007 3:17 PM