Yamaha FX10RTX Offroad Vehicle User Manual


 
Control functions
9
ESU10291
Main switch
The main switch controls the ignition and
lighting systems. The various positions are
described below.
Off
The ignition circuit is switched off.
The key can be removed only in this position.
On
The ignition circuit is switched on.
Start
The starting circuit is switched on.
The starter motor cranks the engine.
CAUTION:
ECS00020
Release the switch immediately after the
engine starts.
NOTE:
The headlights and taillight come on after the
engine is started.
ESU10310
Throttle lever
Once the engine is running cleanly, squeez-
ing the throttle lever will increase the engine
speed and cause engagement of the drive
system. Regulate the speed of the snowmo-
bile by varying the throttle position. Because
the throttle is spring-loaded, the snowmobile
will decelerate, and the engine will return to
idle when it is released.
WARNING
EWS00030
Check the throttle, brake, and steering for
proper operation before starting the en-
gine. (See page 29.)
ESU10321
Engine overheating prevention
system
This model is equipped with a system, which
prevents overheating when the engine is
idling.
When the engine has been idling for 3 min-
utes or longer and the coolant temperature
has risen above 100 °C (212 °F), the engine
automatically stops to prevent overheating.
NOTE:
The engine can be started after it stops.
ESU10344
Throttle override system
(T.O.R.S.)
WARNING
EWS00040
If the T.O.R.S. is activated, make sure
that the cause of the malfunction has
been corrected and that the engine can
be operated without a problem before
restarting the engine.
1. Off
2. On
3. Start
1. Throttle lever
U8GL10E0.book Page 9 Friday, May 18, 2007 3:17 PM