Filter
Top Products
Important:
S
ome newer cars have a plastic safety
c
oating on the inside of the windshield. The
w
indshield bracket may leave permanent marks on this
type of surface. To find out if your vehicle has this type
o
f windshield, check the vehicle’s owner’s manual or
a
sk your dealer. We recommend that you do not
leave the suction cup bracket on the windshield in
direct sunlight. If the detector is removed, this may
c
ause blistering of the dash in some vehicles.
• Slide the detector onto the bracket until it locks into
place. (Image B)
• If necessary, the unit may be leveled by bending the
windshield bracket. Press the bracket release button
and remove the detector before bending.
Power Cord Connection
•
Plug the small end of the power cord into the
unit’s power jack.
• Plug the large end into the vehicle’s cigarette lighter
s
ocket.
N
N
o
o
t
t
e
e
:
:
Cord fits tightly into detector. When
installing the cord, expect some resistance.
Fuse Replacement
The lighter socket plug is equipped with a
r
eplaceable 2 amp, 3AG fuse located behind the
silver tip. To replace the fuse, carefully unscrew the
tip of the plug.
I
I
m
m
p
p
o
o
r
r
t
t
a
a
n
n
t
t
:
:
Unscrew slowly. The tip contains a
spring which may fly out when disassembling.
Insert the new fuse with the spring and screw on
the tip. With use, screw cap on plug may loosen.
Retighten occasionally.
INSTALLATION
INSTALLATION
5
6
Rubber Bumper
(Image B)
Power On Self Test
Each time your Whistler detector is turned on,
an automatic self-test sequence confirms that
the speaker and displays is functional.
• Text Display shows in order:
1
.
W
HISTLER
2.
X-band
3.
K-band
4
.
K
a-band
5. LASER 6
.
.
SR OFF 7. VG2 OFF 8. POP ON
9
.
B
SVR ON
1
0.
H
IGHWAY
Dim/Dark Mode
Dim/Dark Mode re
duces the illumination of the
d
isplay
• Press and release the Dark button to reduce
illumination to a dim setting.
• Press and release the Dark button a second
time to engage Dark Mode. The display
illumination is further reduced.
Dim or Dark can be engaged during an alert. In
Dark Mode, the display goes dark for as long as
a signal is being detected and 20 seconds after,
then the display returns to the dimmer setting.
• Press and release the Dark button a third time
to restore the display to full illumination.
Setting Saver
Setting Saver saves your personalized settings
so that when the detector is turned off and then
on again, you do not have to re-enter them.
Feature Engaged Confirmation
Each time a button is pressed, one beep confirms
feature “on”, two beeps confirm feature “off”.
OPERATION
7