Filter
Top Products
Note The device has a built-in, irreplaceable lithium battery. To avoid the
risk of fire or burning, please do not open, perforate, hit the battery or discard it
in fire or water. The battery will burst, blast or release dangerous chemicals.
When the charge indicator switches on (blue light), it indicates that the
navigation device is in a charging state. Charging requires a few hours, please
be patient and do not cut off power until the blue light is off. When the charge is
completed, remove the adaptor plug from the mains supply.
For later use, when the battery power decreases or is exhausted, please
charge it promptly.
1.2.2 Charging by car adapter:
1. Plug one end of the car adapter into the socket on the left side of the
device body;
2. Plug the other end of the car adapter into the ignition to supply power
for P3 while charging.
Note Please plug the adapter only after the vehicle starts, to avoid damage
caused by instant power impact on equipment.
1.3 Power ON/OFF
ON/OFF is controlled by the power button.
1.3.1 ON
Please check the following:
1 The battery power is adequate, or plugged into the adapter
2 SD card is inserted into the SD/MMC slot correctly, and the inserted SD
card has the system operating program
Press the power button at the back of the machine to turn the device on.
Note During the first orientation please choose an open space with no upper
shelter; Please stay at the same place, for the orientation needs a few minutes
to complete, so wait patiently.
1.3.2OFF
Press the power button at the back of the machine to turn the device off.
1.1.3 Left-side appearance and buttons
Description
Power Socket: DC port is connected with the charge power supply; used
when charging the navigation device
1.2 Charging the device for initial use
1.2.1 For initial use, please charge the battery fully; the steps are as
follows:
1 Plug DC end of charge adapter into the power socket on the left-side of
the device; Plug the other end into the main's supply;
The P3 navigation device has two power supply modes: battery power
supply and main power supply.
When the GPS navigation device is not connected to the charging
adapter,it obtains power from a lithium polymer battery. The battery
consumption sign [ ] is visible on the up left corner of the main
system interface. The battery capacity bar [ ] of the
power-setup interface shows the current residual battery capacity.
When the GPS navigation device is connected to the external charging
adapter, it obtains power from the external power supply.
Attention The Power Adaptor is not included in the accessories we
offer.
This navigation device has a built-in, irreplaceable lithium polymer
battery. Under normal conditions (such as low backlight brightness), a
fully charged battery can continuously work for about 10 hours. The actual
battery supply time varies depending on how you use the GPS navigation
device. Certain functions (audio, video, high brightness backlight)
consume a large amount of energy and may significantly reduce supply
time.
Chapter Chapter
ON OFF button
SD card slot
Earphone Socket
Power Socket
USB Socket
Chapter
Chapter