Filter
Top Products
Source – Volvo AB, Göteborg, Sweden page 24(35)
Reprint 2001 Karl Eric Målberg
On vehicles fitted with Sealed Beam
headlights, follow the instructions under
points 1-4 and then replace the complete
unit.
REPLACING THE BULBS IN THE INNER LIGHTING UNITS
The bulbs are accessible after the shade has been removed by pulling it outwards
REPLACING THE BULBS IN THE
FRONT PARKING LIGHT FLASHER
First loosen the glass in the rim. These
units can be loosened at the same time,
by turning in an anti-clockwise direction.
The bulb is now accessible for
replacement. The bulb has a bayonet
fitting but remember that the pins on the
socket are in different positions.
REPLACEMENT OF BULBS FOR THE
DIRECTIONAL SIGNAL/TAIL LIGHTS
AND STOPLIGHTS
Loosen the screws with a Philips
screwdriver and remove the glass.
The bulbs are now accessible for
replacment. The outer bulb is the
directional signal and the tail lights, the
inner bulb is the stoplight