Filter
Top Products
22
© 2005 directed electronics, inc.
remote press to select page On/Off. One beep is page On,
Two beeps is page Off. When programmed off the remote will not
give any notification that a page was received from the vehicle.
To exit programming mode
The LCD remote control will exit programming mode after 5-
seconds of inactivity and will emit 1 long beep.
uussiinngg yyoouurr ssyysstteemm
The buttons described in this manual correspond to the standard
configuration. Remember, this is not the only way your trans-
mitter may be set up. It can be customised to meet your needs.
active arming
You can activate, or arm, the system by pressing on your
transmitter for one second. When the system arms, you will hear
a short siren sound, or chirp, and the indicator lights will flash
once. If the vehicle’s central door locking has been connected to
the system, the doors will lock.
While the system is armed, the status LED will flash approxi-
mately once per second, indicating that the system is actively
➜
➜
nnoottee::
If programmed Off,
nnoo aallaarrmmss
will be notified to
the remote. Command information (armed/disarmed)
will be notified to the remote.